Torched alder console table // How-To
Torched alder console table // How-To ZH Fabrications
Subscribe
26,981
13,082 views
721 3

 Published On Jan 11, 2017

So this was another commission for the same folks who I built the "Bar Height Slab Table" for. This was a lot of fun! I experimented a bit with some new finishing techniques, and I'm very happy with the results. But I'm also a little bummed that I didn't get a better picture of the finished project, I'm not much of a photographer, but the lighting made it impossible for me to get a good shot.

Anyway, hope you enjoyed the video, I'd love to hear from you!
Zack

Tools used:
Lincoln Electric 140C Mig welder - http://amzn.to/2fhWbGd
Dewalt 4 1/2 Angle Grinder - http://amzn.to/2ejTkbd
Dewalt DW862 Cold Saw - http://amzn.to/2etobWb
Dewalt XR 20V Drill - http://amzn.to/2fMZAxc
Dewalt 20V Circular saw - http://amzn.to/2gxUsgF
Dewalt 20V Jigsaw - http://amzn.to/2hkgLnB
generic propane torch/weed burner - http://amzn.to/2igRlXd

Finishes used:
Boiled Linseed Oil - http://amzn.to/2gnzRc0
Zinsser dewaxed shellac - http://amzn.to/2igPIsw
General Finishes Antique Walnut gel stain - http://amzn.to/2gC75qh
General Finishes HP Top Coat - http://amzn.to/2gajbab

Track list:

1. Imperial Tiger Orchestra - Lale Lale
2. Juanitos - Bailando Boogaloo

Load more Discrition

Share/Embed

Report

Please select the category that most closely reflects your concern about the video, so that we can review it and determine whether it violates our Community Guidelines or isn't appropriate for all viewers. Abusing this feature is also a violation of the Community Guidelines, so don't do it. [email protected]